Category: MAXSON News and Events

Designed for fast and easy size changes, the MSS Sheeter reduces downtime associated with set-up by up to 50 percent. The new sheeter can precisely slit and sheet to an accuracy of +0.015″ (+0.381 mm), eliminating the need to guillotine trim. In addition, the cutter can be outfitted with an automatic mechanism that maintains +0.020″ […]

The UL certification assures the Customer that MAXSON’s equipment has completed an independent, rigorous evaluation process of engineering design, component selection and electrical wiring that meets or exceeds local authority standards. 

The MSS Sheeter is available in widths up to 57″ (1447 mm). Outfitted with a slitter rig, it can produce finished custom sizes in multiple piles. Incorporating an automatic squaring feature and electronic sheet length control that maintains + 0.015″ (+ 0.381 mm) accuracy, size changes require less than 2 minutes. Because cleanliness of the […]

The vibrating back jogger system mounts at the end of the delivery system and protrudes out over the stacker’s load table. By positioning the standardized pallet against the stacker’s backstop, up to 4″ (100 mm) offset of the pile, relative to the skid, can be achieved. In this design, compressed air is introduced at the […]

The cutter’s dual knife technology allows for heavy cutting loads on up to 0.040″ thick (1000 gsm) material while maintaining accuracies of + 0.015″ on sheet lengths and requiring no squareness adjustment. Available in trim widths up to 65″ (1651 mm) the cutter’s standard configuration allows for a 16″ – 65″ (407 – 1651 mm) […]

The sheeter’s drives, logic controller and operator interface have thousands of self diagnostic annunciated faults that identify the specific location or cause of a problem. These faults can be viewed remotely either through a modem using the serial port provided or using the Ethernet port tied into the site’s local area network. In cases where […]

Outfitted with digital drive controls, sheet length is infinitely variable throughout the cutoff range with accuracies within + 0.015″ of the desired setting. A slitting rig prior to the cutter trims oversized rolls to within 0.005″ of the needed width. On a 40″ repeat, the sheeter is able to run at speeds up to 18,000 […]

The floatation system uses up to six casters that incorporate a tough donut shaped bag fastened to a rigid plate. When compressed air is pumped into the caster (via Operator controlled valves), the bag inflates, creating a seal against the floor. When air pressure within the caster is sufficient to offset the load’s weight, air […]

Equipped with dual knife rotary technology, the sheeter is able to cut multiple webs of paper or board, providing dust free edges and insuring high quality printability. Energy conserving regenerative drive systems accurately and squarely produce sheet sizes 16″ – 83″ (407 – 2110 mm) long to within +/- 0.015″ (+/- 0.381 mm) of the […]

The unit is equipped with a stationary bed knife/rotary cutter and is capable of sheeting material from 0.001″ – 0.125″ (0.025 – 3.2 mm) thick. The sheet length can be infinitely varied from 9″ – 36″ (228 – 915 mm) lengths with sheet-to-sheet accuracy of +/- 0.015″ (0.381 mm). A compact unit, the non-woven cutter […]