During setup, the Operator sometimes has difficulty squaring the sheet. Any suggestions?

An out of square cut can be caused by a number of factors.

    • An improper squareness setting is one possible cause for the problems. Check the setting and readjust if necessary.
    • A web that weaves as it feeds into the cutter will also contribute to squareness problems. If this is occurring, adjust the unwind stand for proper squareness and brake tension.
    • An uneven take away pinch roll setting will also cause an out of square cut. To compensate, adjust the tape system pinch roll.
    • Finally, check the doctor boards before the knife for any foreign material. Remove any material stuck to the doctor board.